Ski-Doo Summit 583 1998 - Page 207

Section 05 TRANSMISSION
Subsection 08 (GEARBOX)
05-08-5
Drive reverse shaft
no. 38
out until its LH side
bearing is free.
Make sure gears mesh.
1. These gears must mesh as reverse shaft is driven out
Shift in reverse gear.
Turn reverse shaft so its sliding sleeve dog will not
touch the RH gear of driven pulley shaft
no. 15
.
This will allow the driven pulley shaft to be pushed
out enough for bearing removal.
1. Sleeve dog not touching right gear
2. Brake shaft gears are still in gearbox
Use a puller to extract LH reverse shaft bearing.
1. Extract reverse shaft LH side bearing
To remove sliding sleeve from reverse shaft, first
remove circlip.
A29D0XA
A29D0YA
1
A29D0ZA
1
2
A29D10A
1