69
SJ6826 RT, SJ6832 RT
221587ABA
Fold the guardrails Section 6 – Additional Procedures
5. Use the MEWP ladder to enter the platform.
6. Close the gate.
7. Make sure you fully retract the extension
platform.
8. Remove the lock-pins from the control console
mounting bracket. Put the platform control
console and outrigger/generator control
console down on the platform floor.
WARNING
Fall hazard. To prevent a fall, keep away from the
sides of the platform when you fold or unfold the
guardrails. If you do not obey, there is a risk of
death or serious injury.
9. Remove the locking pin that connects the front
guardrail to the left extension guardrail.
10. Swing the front guardrail to the right extension.
11. Use a tie-wrap to attach the front guardrail to the
right side guardrail.
12. Remove the locking pins on the right-side
extension guardrail.
13. Fold the right-side extension guardrail down with
the front guardrail.
14. Remove the locking pins on the left-side
extension guardrail.
15. Fold down the left-side extension guardrail.
To Next Page
Loading...
Need help?
General
