To Next Page

To Previous Page

6 Connection SMA Solar Technology AG

38 ClusterController-IA-en-10 Installation Manual

3. Insert the eight-pole plug at terminal X8 into pin row A.

4. On the connection cable, mark the terminal and pin row to which the connection cable is

assigned. For this purpose, use the cable ties with the caption field.

5. On the supplementary sheet for noting the connected devices, note the terminal to which the

sensor is assigned.

6. Adjust the characteristic curve of the irradiation sensor or pyranometer via the user interface of

the Cluster Controller (see the Cluster Controller user manual). The measured irradiation values

can therefore be shown on the display and the user interface of the Cluster Controller.

Other manuals for SMA CLUSTER CONTROLLER

Questions and Answers:

Need help?

Do you have a question about the SMA CLUSTER CONTROLLER and is the answer not in the manual?

General