SMART Board 6000S Series Installation And Maintenance Guide

Chapter 3 Connecting computers and other devices
smarttech.com/kb/171414 39

SMART Board 6000S (V3)
SMART Board 6000S and 6000S (C)
Notes
l
If you connect an external speaker system to the display using the Sony/Philips Digital Interface
(S/PDIF) out connector and the audio source device is connected to the display using an HDMI
2.0 connection, the external speaker system must support HDCP 2.2. For more information, see
SMART Board interactive flat panels and High-bandwidth Digital Content Protection (HDCP).
l
The S/PDIF audio is a fixed-volume output. Adjusting the display’s volume for its internal speakers
does not affect the volume output of the S/PDIF port.
Connecting room control systems
A room control system enables users to control a room’s lighting, audio system and, possibly, the display.
Some installations may require you to integrate the display with a room control system.
You can use the display’s RS-232 connector to connect a third-party external control system to the
display (see Appendix D Managing SMARTBoard 6000S (C)or 6000S series displays using RS-232 on
page82 or Appendix C Managing the SMART Board 6000S (V3) display using RS-232 on page74).
Note
Displays are not compatible with centralized remote control systems, such as a universal remote
control.

SMART Board 6000S Series Specifications

General

Resolution	4K UHD (3840 x 2160)
Screen Sizes	65", 75", 86"
Aspect Ratio	16:9
Touch Points	20
Brightness	350 cd/m²
Contrast Ratio	4000:1
Response Time	8 ms
Wall Mountable	Yes
Connectivity	HDMI, USB, VGA, DisplayPort
Operating System	Android