Chapter 2
Installing the display
smarttech.com/kb/171744 28
3. Toggle the Wifi Switch to on.
4. Select a wireless network.
If the Wi-Fi network is not password protected, the display connects to the network.
OR
If the network requires a password, enter the Wi-Fi password and tap Connect.
To connect to an Ethernet network
1. Connect an Ethernet cable to either of the RJ45 jacks on the display.
2.
Press the Settings button on the front control panel.
3.
Tap the Network icon > Ethernet.
4. Turn on the Connect switch.
5. To obtain an IP address automatically, select the DHCP checkbox.
OR
To configure an IP address manually, select the Static checkbox, input the IPaddress, gateway,
network prefix length (netmask bit count), and DNSaddress, and tap Save.
To configure a wireless hotspot
NOTES
l The wireless hotspot feature is available when the display is connected to the network with an
Ethernet connection.
l When the wireless hotspot is enabled, the display’s Wi-Fi connection is disabled.
1.
Press the Settings button on the front control panel.
2.
Tap the Network icon > Hotspot.
3. Enable the Hotspot Switch option.
4. Type a hotspot name in the Hotspot Name text box (or use the default name).
5. In the Security field, tap the drop-down list and select a method of encryption.
6. Click Show Password and record the system generated (default) password or type your own
password. This password will be required when users connect their devices to the wireless hotspot.
To Next Page
Loading...
Need help?
General