SMART CX01 - Single Satellite

Extended Settings and Functions
smart CX01 127
3. Align your motor antenna so that signal strength and signal quality (are dis-
played at the lower screen edge) reach maximum values.
4. Press EXIT to return to the submenu Antenna Setup.
¾ In the submenu Antenna Setup, select the item Limit Setup and press OK to
open the window Limit Setup. Proceed as described above.
7.2.4 Single Satellite
Here you can scan individual satellites for receivable channels.
¾ At Satellite, select the satellite for which the scan should be performed.
)
Also here, options are limited to the satellites that are marked
in the Satellite List as such satellites from which you want to
receive channels.
¾ Select Only FTA
12
to determine if scan should be made only for FTA channels or
for all channels.
¾ At Scan Channel, select if you want to perform scan only for TV channels, only
for radio channels or for TV + radio channels.
¾ At Network Search, select if you want to search for an individual channel (No)
or all channels of a channel network (Yes), e.g. PRO7, SAT1, KABEL1, SIXX. The
item Network Search will only be active after selecting the scan mode Preset
Scan (i.e. Standard Scan).
¾ At Scan Mode, select the scan mode:
 Preset Scan (Standard Scan): In such mode, only the frequencies included
in the TP list are regarded.
 Auto Scan (Blind Scan): Here, all frequencies are scanned, whether they are
included in the TP list or not.
¾ At Tuner, select the LNB to process the signals (if only one LNB is present, then
this item will not be active).
¾ Start channel search by selecting Search and confirm by pressing OK.
12
FTA = Free To Air = unencrypted channels