SMART CX01 - Connect Power Supply; Insert Batteries of Remote Control

Installation of smart CX01Fehler! Unbekannter Name für Dokument-Eigenschaft.
smart CX01 93
4.6 Connect Power Supply
¾ When all devices are properly connected to the receiver you can connect the
mains plug to the power outlet.
4.7 Insert Batteries of Remote Control
This describes the steps for inserting new batteries of the remote control or
for replacing empty batteries:
1. Open the battery compartment on the bottom side of the remote control. Re-
move the cover of the battery compartment.
2. Place the two batteries 1.5 V (type: AAA).
Ensure correct polarity!
3. Close the battery compartment
)
¾ Replace the batteries if certain remote control functions are
not performed any more or are performed incorrectly.
¾ When replacing batteries, always ensure that all batteries
are replaced.