SMC Networks HRSH200-A*-20 Series - Page 118

HRX-OM-Q026-B
Chapter 5 Display and setting of various functions
5.20 Alarm customizing function HRSH Series
5-58
25. Select the changing of contact input signal 1 detection from the table below with [▲]
key or [▼] key, and confirm by pressing “SEL”.
Table 5.20-19 List of set value
Set value Explanation
Initial value
(Default setting)
This alarm signal is not detected.
Operation continues when this alarm signal is
generated.
Operation is stopped when this alarm signal is
generated.
○
Changing of Contact input signal 2 detection Setting and checking
26. Press the [SEL] key once.
The set screen of the changing of contact input signal 2 detection is displayed on the
digital display.
PV
SV
27. Select the changing of contact input signal 2 detection from the table below with [▲]
key or [▼] key, and confirm by pressing “SEL”.
Table 5.20-20 List of set value
Set value Explanation
Initial value
(Default setting)
This alarm signal is not detected.
Operation continues when this alarm signal is
generated.
Operation is stopped when this alarm signal is
generated.
○
Changing of DC line fuse cut Setting and checking
28. Press the [SEL] key once.
The set screen of the changing of DC line fuse cut is displayed on the digital display.
PV
SV