HRX-OM-Q026-B
Chapter 7 Control, Inspection and Cleaning
HRSH Series 7.2 Inspection and Cleaning
7-3
7.2.2 Monthly check
Cleaning of air ventilation
Clean the dust-proof filter with a long bristled brush or by air purging to
prevent the fins from being deformed or damaged.
Cleaning of the dust-proof filter
1. The dust-proof filters are installed on the front and left side of the product.
There are totally four filters and all they have the same shapes.
2. They can be removed as shown in the drawing below.
Care should be taken not to deform or scratch the air-cooled condenser (fin) while the
removal.
Fig. 7-1 Removal of the dust-proof filter
z If the air ventilation of the product have clogged with dust or
debris, heat radiation performance reduces. This results in the
reduction of cooling performance, and may stop the operation.
To Next Page
Loading...
