HRX-OM-Q026-B
Chapter 3 Transport and Setting Up
HRSH Series 3.1 Transport
3-1
Chapter 3 Transport and Setting Up
3.1 Transport
The product is heavy and has potential danger at transport. Also, to prevent
damage and breakage of the product, be sure to follow these instructions for
transport.
z Drain the residual fluid from the piping as much as possible to
prevent any spillage.
z Only persons who have sufficient knowledge and experience
about the product and system are allowed to transport and set up
the product.
z Especially pay attention to personal safety.
Never lay the product on its side.
The compressor oil will leak in to the refrigerant piping, which may
cause early failure of the compressor.
z When moving by folklift, take care not to hit the folk to the cover
panels and piping ports of the product.
z Be sure to use all the four eye bolts when sling the product.
z The slant angle of each rope should be less than 60 degrees.
z When moving the product by a folklift, insert the fork into the right
psitions refering to 3.1.1
Moving by forklift and slinging.
To Next Page
Loading...
Need help?
General
