SMC Networks HRSH200-A*-20 Series - Page 132

HRX-OM-Q026-B
Chapter 5 Display and setting of various functions
5.21 Communication function HRSH Series
5-72
18. Select BCC (simple communication protocol) from the table below with [▲] key or [▼]
key, and confirm by pressing “SEL”.
Table 5.21-10 List of set value
Set value Explanation
Initial value
(Default setting)
Setting/checking are not available unless the
serial protocol setting is simple
communication protocol.
Without BCC
With BCC
○
Data length (simple communication protocol) Setting and checking
19. Press the [SEL] key once.
The set screen of data length (simple communication protocol) is displayed on the digital
display.
PV
SV
20. Select data length (simple communication protocol) from the table below with [▲] key or
[▼] key, and confirm by pressing “SEL”.
Table 5.21-11 List of set value
Set value Explanation
Initial value
(Default setting)
Setting/checking are not available unless the
serial protocol setting is simple
communication protocol.
7 bit
8 bit
○
Parity check (simple communication protocol) Setting and checking
21. Press the [SEL] key once.
The set screen of parity check (simple communication protocol) is displayed on the
digital display.
PV
SV