HRX-OM-Q026-B
Chapter 3 Transport and Setting Up
HRSH Series 3.3 Installation
3-17
2. Connect the signal cable and switch to the terminal as follows. (This wiring is an
example.)
Fig. 3-9 Wiring of Run/stop signal input･Remote signal input （Example）
Inlet of the signal
cable
Note: Prepare a cable tie.
Fasten the signal cable to the
mount on the base by the cable
tie.
Terminal No. 5
Terminal No.13
Terminal No.11
Switch
Mount for cable tie
Terminal No. 3
To Next Page
Loading...
