HRX-OM-Q026-B
Chapter 5 Display and setting of various functions
5.1 Function HRSH Series
5-6
Table 5.1-3 List of parameter (3/3)
Display Content Default setting
Reference
page
Category
Changing of circulating fluid pressure
sensor error
A.STP
Changing of the pump maintenance
A.STP
Changing of the fan maintenance
OFF
Changing of the compressor
maintenance
OFF
Changing of the dust-proof filter
maintenance
A.RUN
Changing of the recovery from power
failure
A.STP
5.20
Alarm setting
menu
Communication mode LOC
Serial protocol MDBS
Communication specifications 485
RS-485 terminal OFF
Slave address
1 (----)∗8
Mod
bus
Communication speed
19.2 (----)∗8
Slave address
---- (1)∗8
Communication speed
---- (9.6)∗8
BCC
---- (ON)∗8
Data length
---- (8BIT)∗8
Parity check
---- (NON)∗8
Stop bit length
---- (2BIT)∗8
Response delay time
---- (0)∗8
Serial communication
Simple
communication
protocol
Communication range
---- (RW)∗8
Contact input signal 1 RUN
Contact input signal 1 type ALT
Contact input signal 1 delay timer
(time delay) of reading
---- (0)∗8
Contact input signal 1 OFF
detection timer
---- (0)∗8
Contact input signal 2 OFF
Contact input signal 2 type ALT
Contact input signal 2 delay timer
(time delay) of reading
---- (0)∗8
Contact input signal 2 OFF
detection timer
---- (0)∗8
Contact output signal 1 function
RUN
Contact output signal 1 operation
A
Contact output signal 1 selected
alarm
---- (AL.01) ∗8
Contact output signal 2 function
RMT
Contact output signal 2 operation
A
Contact output signal 2 selected
alarm
---- (AL.01) ∗8
Contact output signal 3 function ALM
Contact output signal 3 operation B
Contact input/output communication
Contact output signal 3 selected
alarm
---- (AL.01) ∗8
5.21
Communicati
on setting
menu
∗8: Regarding the detail of the default setting, refer to “5.21Communication function”.
To Next Page
Loading...
