Part in contact with
fluid
A part that comes into physical contact with the fluid.
Indicates the change in the display value and analogue output when fluid pressure
changes.
Burst pressure at which the product is electrically or mechanically damaged.
The flow range within which the product will meet all published specifications.
The pressure range that satisfies the specifications.
Reproducibility of the display or analogue output value, when the measured quantity is
repeatedly increased and decreased.
The range of ON/OFF threshold values that can be set for those products with a switch
output.
Output type that has only 2 conditions, ON or OFF. When in the ON condition an
indicator light will show, and any connected load will be powered. When in the OFF
condition, there will be no indicator light and no power supplied to the load.
Temperature
characteristics
Indicates the change in the display value and analogue output caused by ambient
temperature changes.
A function to select display units other than the international unit (SI unit) specified in
the new Japanese measurement law. Flow can only be displayed by SI units in Japan.
An operating mode in which the switch output is turned on and off depending on
whether the flow is inside or outside the range of two set values.
A measure of the product’s resistance to a voltage applied between the electrical circuit
and case. Durability in withstanding voltage. The product may be damaged if a voltage
over this value is applied.
(The withstand voltage is not the supply voltage used to power the product.)
This function to adjust the displayed flow to zero.
To Next Page
Loading...
Need help?
General
