Servodrives / inverters series COSMOS 301X Installation, use and maintenance manual - EN
5.7.16 0 to 10V analogue output
Some versions of the servo-drive/inverter are equipped with an analogue output stage for 0 to 10V. This type
of interface is normally used to transmit certain measurements, such as motor rotation speed, in an analogue
way, to other devices (such as a PLC).
The recommended connection diagram is shown in the following picture:
In order to avoid signal corruption, it is recommended to use a shielded cable.
Ver. 1.09 SMITECdd 57/74
To Next Page
Loading...