Servodrives / inverters series COSMOS 301X Installation, use and maintenance manual - EN
Address 0 can not be used; each device on the same bus must have a different address. The presence of
two devices with the same address creates communication problems and may cause the system to behave
uncontrollably.
Since the address is read only when the device is switched on, the address must be set before powering the
system, otherwise it will not be possible to see the modifications until the system re-starts.
CAUTION
Make sure the address is correct before powering up the devices; otherwise the system
may behave uncontrollably; risk of danger to persons and/or property.
ATTENTION
Vérifiez l'exactitude de l'adresse avant de mettre les périphériques sous tension, sinon le
système pourrait avoir un comportement imprévisible. danger de dommages aux
personnes et / ou aux choses.
For further details about FLxIO bus operation and types of connection, please refer to the specific
documentation.
Ver. 1.09 SMITECdd 61/74
To Next Page
Loading...