- 24 -
A positive number for a frame after the trigger point.
A negative number for a frame before the trigger point:
e: Press Y to switch the thumbwheel function back and forth from scrolling
frames to scrolling data within a frame.
5: With Y set so the thumbwheel scrolls data, the frame number remains stationary
and does not flash. With Y set to scroll frames, the frame number flashes.
6: Scrolling from frame to frame, the data lines on the screen will stay in the
same position. Parameter names will not change, but readings may change
as different values were recorded from frame to frame.
7: Scrolling data lines within a frame, the thumbwheel moves the lines from top
to bottom within that frame. It does not roll over into an earlier or later frame.
8: Data or test mode titles and trouble code information are on lines 2 and 3 of
each frame and can be scrolled off as in normal data viewing. Codes may
change from frame to frame as recorded; the mode title does not change.
9: LEDs flash to indicate the state of the selected LED assignments from frame
to frame.
10: Lines may be fixed with the fix line 2 or 3 options on the “Exit” menu. Fixed
lines remain fixed during horizontal and vertical scrolling until released through
the “Exit” menu. Fixed lines also remain fixed during “Exit” and “Resume”
operations.
11: When resuming reviewing a movie from the “Exit” menu, resume will occur at
the last screen and frame viewed before exiting.
12: When resuming reviewing a movie, thumbwheel scrolling operation stays in
the condition last selected by pressing Y before exiting.
13: Press N to exit from “Review Movie” at any time.
*******
OPERATION
1 RPM 1234 O2 (mV) 689 BATT (V) 13.5
-1 RPM 1234 O2 (mV) 689 BATT (V) 13.5
To Next Page
Loading...
Need help?
General
