- 29 -
OPERATION
11: CUSTOM SETUP
Allows the selection of certain Scanner functions for a customized setup:
• Set parameters for communication between Scanner and a PC or printer.
• Change English/Metric units.
• Assign functions to the 4 LED’s or Right / Left Hand Drive Setup
• Backlight setting.
Use the Thumbwheel and the Y and N buttons to select and deselect the various
options.
NOTE: “Right/Left Hand Drive Setup” will only be displayed in the start-up
menu where applicable.
COMMUNICATION SETUP
Use this selection to set the baud rate for RS 232 serial communication with a PC
or a printer. The possible selections are as follows:
a: MT1670 Printer, (2400 baud)
b: Other communication, 4800 baud
c: Other communication, 9600 baud
d: Other communication, 19200 baud
ENGLISH / METRIC
Use this selection to adjust the units of measurement displayed during testing.
The possible settings are as follows:
Temperature,
o
C or
o
FAir Pressure, kPa or “Hg
Vehicle Speed, MPH or KPH Other Pressure, PSI or kPa
RIGHT / LEFT HAND DRIVE SETUP, (If Applicable)
When the Scanner is first powered-up with no vehicle selected or identified the
“Right / Left Hand Drive Setup” will be displayed on the Custom Setup Menu.
It is recommended to select whether the vehicle to be tested is a right or a left
hand drive before it is identified. This is because some of the messages displayed
may vary depending on the type of drive selected.
>COMMUNICATION SETUP
ENGLISH / METRIC
LED MENU
CONTRAST ADJUST
To Next Page
Loading...
Need help?
General
