- 30 -
OPERATION
LED MENU
Parameters can only be selected to be On/Off, or Open/Closed or Rich/Lean.
This is useful for a quick check when driving or accelerating to check whether a
switch or an actuator is operating correctly under normal driving conditions.
To change the L E D assignment, s c r o l l to select the c h o i c e and p r e s s Y to set.
The various LED assignments may be different for each vehicle selected.
CONTRAST (BACKLIGHT) ADJUST
Use this selection to adjust the Backlight setting. When the Scanner is powered
from the vehicle the Backlight is always set to ON and can not be adjusted.
When the Scanner is powered from the PowerPac the Backlight can be switched
ON or OFF by pressing and holding N for 4 seconds anytime. For the auto-shut
off selection press Y. The possible selections are as follows:
a: Turn off after 2 minutes of inactivity
b: Turn off after 5 minutes of inactivity
c: Don’t automatically turn off Backlight
*******
To Next Page
Loading...
Need help?
General
