3.4 Driving Safety
Note:
1. The
Driving Safety
function is limited to triggering no more than two alarms at the
same time. If a voice and alert message have been triggered, any other alarm will be
ignored until either of the two is settled.
2. Satellite positioning must be completed before functions such as
Speed Cam Alert
,
Speed Position Management
,
Speed Limit Alert
,
LDWS
and
FCWS
should be
enabled. Be sure to check that Satellite positioning has been completed prior to using
the product.
3. The detections of
LDWS
and
FCWS
may be inaccurate when used in rain, at night or
in environments with insufficient lighting. Drivers are advised to exercise discretion
based on actual road conditions.
3.4.1 Speed Cam
Alert
If the Speed Cam Alert function is enabled, once your car’s
location is determined by GPS and approaches a speed cam, this
product produces an audible alert and onscreen message.
To enable the Speed Cam Alert:
1. Press the button to enter the OSD menu.
2. Press the / button to select Speed Cam Alert, and
then press the button to enter the function menu.
3. Press the / button to select On, and then press the
button to enable
the function.
4. Press the button
to return to the recording
screen.
5. The alarm screen turns
red to remind you to slow
down if you are driving
faster than the speed limit.
Note:
The
Speed Cam Alert
function must have the speed cam datum from the country you use.
The function will be void if the product is used in any other countries. Please consult with the
shop you purchased from if the function is void. There is no guarantee the speed cam datum
will be included for other countries.
To Next Page
Loading...
