Notes on Installation
1. Before installing the device, measure the front windshield
viewing area, make sure not to block the driver's front view,
install the device below the rear view mirror (the central, higher
right position of the front windshield). And we recommend that
the sky and the land each occupy 50% of the screen, fix the car
holder and then adjust the device so that the lane ahead is
aligned with the screen. Proper installation enables the device
to maximize the efficiency and can also enhance the accuracy
of LDWS.
2. Make sure that the lens is within the wiping range of the
windscreen wiper to ensure a clear view when it rains.
3. Do not touch the lens with your fingers. Finger grease may be
left on the lens and will result in unclear videos or pictures. Clean
the lens on a regular basis.
4. Do not install the device on a tinted window. Doing so may
damage the tint film.
5. Make sure that the installation position is not hindered by the
tinting on a window.
6. This product is suitable for light windshield or light colour heat-
resistant film windows, it will affect video quality if it is installed
on dark tinted windows or windows with dark heat-resistant film.
7. Only use the supplied battery charger. Do not use any other
branded battery charger, using any other charger may cause
damage to your equipment or may cause the battery to explode.
8. The suction cup bracket is designed for temporary mounting
and will require periodic re-installation. The adhesive bracket is
designed for one time and long term installation. We recommend
using the adhesive bracket if permanent installation is desired.
We are NOT liable for any damages or data loss due to improper
bracket mounting or the suction cup bracket losing suction and
falling off.
To Next Page
Loading...
