SODICK A320D - Page 134

Wire EDM Machine Operation Chapter 11
Copyright November, 98 Page 11-14 Sodick Inc.
P
P
R
R
A
A
C
C
T
T
I
I
C
C
E
E
E
E
X
X
E
E
R
R
C
C
I
I
S
S
E
E
S
S
C
C
H
H
A
A
P
P
T
T
E
E
R
R
E
E
I
I
G
G
H
H
T
T
Taper Cutting
1) What are some popular reasons for taper cutting?
________________________________________________________________________
2) What are the programming words related to taper cutting and what is each one’s
meaning?
________________________________________________________________________
________________________________________________________________________
3) What are the three steps to programming taper?
1)________________________________________________________________
2)________________________________________________________________
3)________________________________________________________________
4) If you were machining a die with the top of the die “up” and the program commanded
that the wire move around the die in a “counter clockwise” direction, which G code
would you use to instate taper?
________________________________________________________________________
5) Define the following parameters (in relation to the worktable):
Table To Limit :
Table To Upper :
Table To Lower :
Table To Program :
Table To Next :