SODICK A320D - Chapter 15: CRT Screens; Screen Default Parameters

Wire EDM Machine Operation Chapter 15
Copyright November, 98 Page 15-1 Sodick Inc.
C
C
H
H
A
A
P
P
T
T
E
E
R
R
1
1
5
5
C
C
R
R
T
T
S
S
C
C
R
R
E
E
E
E
N
N
S
S
S
S
C
C
R
R
E
E
E
E
N
N
D
D
E
E
F
F
A
A
U
U
L
L
T
T
P
P
A
A
R
R
A
A
M
M
E
E
T
T
E
E
R
R
S
S
This chapter looks at some of the CRT screens in the control. The screens shown in this
manual describe some of the most common parameters used. This manual is not meant to
replace the “CONTROL SYSTEM” manual supplied with the machine. The latest
version of the Control System manual is volume 3.0A (p.n. 6100259). This manual is
available from the parts department.
On the “SET” screens there are parameters which are considered preference settings.
These affect the way the machine acts when you graph, dryrun or cut a program. The
operator should be aware of the most common ones and what they affect and then decide
how he wants the machine to act and set them accordingly.
NOTE: After you change any of the parameters, the changes are saved automatically
when you exit the screen you were working on. When the control is sourced on, it will
boot up with the parameter settings set the way they were when the machine was sourced
off.