SODICK A320D - Amp - Voltmeters; Amp Meter; Additional Switches; Arrow U P - down Switch

Wire EDM Machine Operation Chapter 2
Copyright November, 98 Page 2-7 Sodick Inc.
A
A
M
M
P
P
-
-
V
V
O
O
L
L
T
T
M
M
E
E
T
T
E
E
R
R
S
S
The Amperage and Voltage meters are located to the right of the Sub-panel. These meters
are used during machining to show the status of the power supply.
AMP METER
When the IP is at 16 or 17 read the top scale on the AMP meter (0-40). When the IP is
15 or lower read the lower scale (0-4).
A
A
D
D
D
D
I
I
T
T
I
I
O
O
N
N
A
A
L
L
S
S
W
W
I
I
T
T
C
C
H
H
E
E
S
S
ARROW UP – DOWN SWITCH
On a MARK21 control there is a switch directly to the left of the KB- RC switch that has
up and down arrows by it. This switch is not used.
E STOP BUTTON
On the control, there is a large red push button. This button turns off the “POWER” to the
machine (all pumps, motors). If it is pressed the “SOURCE” remains on, and the
computer is still powered up. DO NOT lean on the table with the power off, as you will
lose location. It is also wise to check the negative limits whenever turning the “POWER”
switch back on.
To completely shut down the machine, also press and release the “SOURCE” switch.
HOUR METER
This meter displays the machining hours on the machine. The small switch located on the
meter can be used to reset the meter to zero. To reset the meter to zero, slide the switch
up and press it in. To lock the reset switch, leave it in the down position.