SODICK A320D - Page 136

Wire EDM Machine Operation Chapter 11
Copyright November, 98 Page 11-16 Sodick Inc.
________________________________________________________________________
Automatic Corner Rounding:
12) What is the difference between using G02 and G03 as they compare to using
automatic corner rounding.
________________________________________________________________________
13) With automatic corner rounding, what programming word (letter address) specifies
the desired radius?
________________________________________________________________________
14) What is the major limitation to using this feature (making it almost mandatory to use
G02 and G03)?
________________________________________________________________________
Scaling:
15) Is there any programming word related to scaling?
________________________________________________________________________
16) If you wanted to run a program, scaling it up to twice programmed size, what value
would you enter as the scale factor (in the RUN mode)?
________________________________________________________________________
Mirror Image and Axis Rotation:
17) What is the difference between G05 mirror image X and G93 mirror image X? Which
one is almost NEVER used.
________________________________________________________________________
18) What is the purpose of having these features (mirror image and axis exchange)?
________________________________________________________________________
Axis Rotation:
19) What are the programming words related to axis rotation?
________________________________________________________________________
What are their functions?
________________________________________________________________________