Wire EDM Machine Operation Chapter 14
Copyright November, 98 Page 14-4 Sodick Inc.
that there is a more accurate sensor touch routine that actually touches the edge three
times and takes the average of the three touches.
Using the X and Y jog keys, position the wire close to the edge to be touched.
2) Turn wire run on manually with speed at 2 and tension at 8.
3) Press the (red) ST key and hold it while pressing one of the X or Y keys to jog the wire
into the edge using MFR speed 1 or 2.
4) When the wire touches the part, it will automatically move back and stop. When
finished, the buzzer will sound.
5) Press the “ACK” key.
6) The edge of the wire is now flush with the edge of the part. Press down the wire run
switch to turn the wire run off.
To Next Page
Loading...