Wire EDM Machine Operation Chapter 14
Copyright November, 98 Page 14-18 Sodick Inc.
editing functions can be performed. All editing functions require that the program be
loaded into memory and then press the soft key next to “EDIT”.
To search for information in memory:
1) Press the soft key below SCH / RPLC.
2) Move the cursor to select SEARCH UNDER THE WORD or SEARCH
ABOVE THE WORD. This means search above or below where the cursor is currently
located on the CRT screen. Press “ENTER” when ready.
3) Type the information you wish to search for.
4) Press “ENTER”. If the info. cannot be found, it will promt you in the lower left
corner.
5) The cursor will move to the first location of the information.
6) To continue searching, press “ENTER”. If no more info., it will prompt you.
7) To stop searching, press “ESC”.
To replace information in memory:
1)Press the soft key below SCH / RPLC.
2) Move the cursor with the arrow keys to select REPLACEMENT OF THE WORD and
press “ENTER”.
3)Type the information to be replaced and press “ENTER”.
4) Type the replacement information and press “ENTER”.
5) Press (Y) for yes or (N) for try next or “ESC” to stop..
To exchange information in memory:
1) Press the soft key under EXCHANGE/ INSERT so it highlights exchange.
2) Move the cursor to the information you want to replace with other information.
3) Type in the new data and the old data is replaced.
To insert information in memory
1) Move the cursor to the information AFTER where you want to insert data.
(The inserted data will go before, where the cursor currently is).
2) Press the soft key under “INSERT”so it highlights INSERT .
3) Type the new data and it inserts the information.
To mass delete information in memory or to relocate that information elsewhere:
1) Search to the first character to be deleted.
2) Press the soft key under “AREASET”.
3) Bring the cursor to the last character to be deleted (characters to be deleted will be
highlighted).
4) Press the soft key under “DELETE”.
To Next Page
Loading...