Wire EDM Machine Operation Chapter 4
Copyright November, 98 Page 4-2 Sodick Inc.
Program for figure 4-1
N005 G54 (SELECT COORDINATE SYSTEM A00)
N010 G92 X.250 Y-.300 (SET PROGRAM ZERO)
N015 G90 (SELECT ABSOLUTE MODE)
N020 C411 (SELECT CUTTING CONDITION)
N025 G42 H061 (SELECT RIGHT OFFSET AND VALUE)
N030 T94 (SUBMERGE MODE )
N031 T91 ( AUTO WIRE THREAD)
N035 T84 (HIGH PRESSURE FLUSH ING)
N040 G01 Y0 (MOVE UP IN Y)
N045 X.5 (MOVE TO THE RIGHT)
N050 Y.500 (MOVE UP IN Y)
N055 X0 (MOVE TO THE LEFT)
N060 Y0 (MOVE TO PROGRAM ZERO)
N065 X.150 (MOVE TO MOO POINT)
N070 G40 Y-.02 (MOVE TO POINT 8 AND CANCEL OFFSET)
N075 M00 (PROGRAM STOP TO SUPPORT PART)
N080 G01 X.250 (MOVE TO ENTRY LINE)
N090 G01 Y-.300 (MOVE BACK TO START POINT)
N095 M02 (END OF PROGRAM)
The information in each command may be foreign to you yet. The control will start
executing this program from the command beginning with N005. When it finishes with
line number five, it will go on to line number ten, then to line number fifteen, and so on.
All programs will be executed sequentially, one command at a time.
NOTE: The information inside parenthesis are messages for you to read. The control
ignores the information.
The “N” words are sequence numbers. They are not required to be in the program, unless
your using sub routines. However, we recommend that beginners use them in each
program and keep them in a logical order for program line identification purposes.
To Next Page
Loading...