Wire EDM Machine Operation Chapter 5
Copyright November, 98 Page 5-7 Sodick Inc.
(The wire is cut at the start of this program and there is no AWT):
N005 G59 G92X0Y0(VALUES SET FOR G59 DURING SETUP)
N010 G00 X.75 Y.5 (MOVE TO POINT 1)
N015 M00 (PROGRAM STOP TO THREAD WIRE)
N020 G54 (SELECT COORDINATE SYSTEM)
N025 G92 X.3 Y-.2 (SET PROGRAM ZERO)
N030 C411 (SELECT CONDITION)
N035 G90 (SELECT ABSOLUTE MODE)
N037 T84 (TURN ON HIGH FLUSH PUMP)
N040 G42 H062 (SELECT OFFSET DIRECTION AND VALUE)
N045 G01 Y0 (MOVE TO POINT 2)
N050 X.4 (MOVE TO POINT 3)
N055 G03 X.5 Y.1 J.1 (MOVE TO POINT 4)
N060 G01 Y.4 (MOVE TO POINT 5)
N065 G03 X.4 Y.5 I-.1 (MOVE TO POINT 6)
N070 G01 X.1 (MOVE TO POINT 7)
N075 G03 X0 Y.4 J-.1 (MOVE TO POINT 8)
N080 G01 Y.1 (MOVE TO POINT 9)
N085 G03 X.1 Y0 I.1 (MOVE TO POINT 10)
N090 G01 X.2 (MOVE TO POINT 11)
N095 G40 Y-.02 (MOVE TO POINT 12, CANCEL OFFSET)
N100 M00 (STOP TO APPLY MAGNETS OR CLAMP)
N105 G01 X.3 (MOVE TO POINT 13)
N110 Y-.2 (MOVE BACK TO POINT 1)
N115 M02 (END OF PROGRAM)
Careful study of the program will reveal how the part (figure 5-7) is formed using the
movement commands just described.
In the following chapters you will learn more of the techniques used in the above
program (Offset use).
To Next Page
Loading...