SolarEdge SE66.6KUS - Installation Equipment List

Installation Equipment List
StandardtoolscanbeusedduringtheinstallationoftheSolarEdgesystem.Thefollowingisa
recommendationoftheequipmentneededforinstallation:
l Allenscrewdriverfor5mmscrewtypefortheinvertercover,ConnectionUnitcover,andinverterside
screws
l 17/32HEXAllenscrewdriverforACstudconnector
l SolarEdgesuppliedlevel
l SolarEdgesuppliedDC/interlockconduit(s)
l Standardflat-headscrewdriversset
l Non-contactvoltagedetector
l Cordlessdrill(withatorqueclutch)orscrewdriverandbitssuitableforthesurfaceonwhichthe
inverterandoptimiserswillbeinstalledandforopeningtheConnectionUnitdrillguides.Useofan
impactdriverisnotallowed.
l Appropriatemountinghardware(forexample:stainlessbolts,nuts,andwashers)forattaching:

o
thePrimaryandSecondaryUnit(s)mountingbracketstothemountingsurface

o
thepoweroptimiserstotheracking(notrequiredforsmartmodules)
l 4xM8ringterminalsandsuitablecrimper
l Wirecutters
l Wirestrippers
l Voltmeter
Forinstallingthecommunicationoptions,youmayalsoneedthefollowing:
l ForEthernet:

o
CAT5/6twistedpairEthernetcablewithRJ45connector

o
IfusingaCAT5/6cablespool:RJ45plugandRJ45crimper
l ForRS485:

o
Four-orsix-wireshieldedtwistedpaircable.

o
Watchmakerprecisionscrewdriverset
Chapter 1: Introducing the SolarEdge Power Harvesting System
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
13