SolarEdge SE66.6KUS - Device Manager; Maintenance

TheEnergyManageroptionisusedforsettingpowerexportlimitation,
asdescribedintheExportLimitationApplicationNote,availableonthe
SolarEdgewebsiteat
https://www.solaredge.com/sites/default/files/feed-in_limitation_
application_
note.pdfhttps://www.solaredge.com/sites/default/files/export_
limitation_application_note_NA.pdf.

ForP(Q)diagramrefertohttps://www.solaredge.com/sites/default/files/application_
note_p_q_diagram_of_se_inverters_en_and_na.pdf.
NOTE
SolarEdge inverters with “Grid Support” functionality (as marked on the inverter certification label), are
compliant with UL 1741 Supplement A. The functionality is built into the inverter and no additional
external device is required.
Device Manager
FromtheCommissioningmenu,selectDevice ManagertoconfigurevarioussystemSmartEnergy
Managementdevices.
Formoreinformationrefertohttps://www.solaredge.com/products/device-control#/.
Maintenance
FromtheCommissioningmenu,selectMaintenancetoconfigurevarioussystem
settings,asdescribedbelow.
l Date and Time:Settheinternalreal-timeclock.Ifconnectedtothemonitoringplatform,thedate
andtimearesetautomaticallyandonlytimezoneshouldbeset.
l Reset Counters:Resetstheaccumulatedenergycountersthataresenttothemonitoringplatform
l Factory Reset:Performsageneralresettothedefaultdevicesettings.
l Arc Fault Circuit Interrupter (AFCI):Enablesordisablesproductioninterruptionincaseofarc-fault,
setsthereconnectionmode,andenablesordisablesmanualAFCIself-test.
Refertohttp://www.solaredge.com/sites/default/files/arc_fault_detection_
application_note_na.pdf.
l Firmware Upgrade:Performasoftwareupgrade.
l Load / Save Configuration:Enablessavingorloadingsystemparametersfromone
invertertoanother.
l Diagnostics:DisplaystheIsolationstatusandpoweroptimiserstatus
screens.Referto
https://www.solaredge.com/sites/default/files/application_note_
isolation_fault_troubleshooting.pdf.
l Activate Standby Mode:Enables/disablesStandbyMode-for
remotecommissioning.
l Grid Protection:Availableinspecificcountries.Enablesviewingandsettinggridprotectionvalues.
l Board Replacement:Backsupandrestoresthesystemparameters,includingenergycounters;Used
duringboardreplacementaccordingtotheinstructionssuppliedwithreplacementkits.
Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
45