SolarEdge SE66.6KUS - Commissioning and Configuration

Step 2: Commissioning and Configuring the
Installation
ThissectiondescribeshowtousetheSetAppmenusforcommissioningandconfiguringtheinverter
settings.
Menusmayvaryinyourapplicationdependingonyoursystemtype.
To access the Commissioning screen:
Dooneofthefollowing:
l Duringfirsttimeinstallation:UponActivationcompletion,intheSetApp,tapStart Commissioning.
ThemainCommissioningmenuscreenisdisplayed.
l Iftheinverterhasalreadybeenactivatedandcommissioned:
a. IfnotalreadyON-turnONACtotheinverterbyturningONthecircuitbreakeronthemain
distributionpanel.
b. IfnotalreadyON-movetheConnectionUnitswitchtotheONposition.
c.
OpenSetAppandfollowtheinstructionsonthescreen(scantheinverterbar-code;movethe
ON/OFF/PswitchtoPposition(forlessthan5sec)andrelease).
ThemobiledevicecreatesaWi-Ficonnectionwiththeinverteranddisplaysthemain
Commissioningscreen.
Inthemainmenus,tapthemenuredarrows(›)toperformthesystemcommissioningorconfiguration
task.TaptheBackarrow(‹)toreturntothepreviousmenu.
Thenextsectionsprovidemoreinformationaboutconfigurationoptions(inadditiontoCountry and
LanguageandPairing,describedinStep2:CommissioningandConfiguringtheInstallationonpage43).
Setting Country and Language
1.
FromtheCommissioningscreenselectCountry and Language.
2.
FromtheCountrydrop-downlist,selecttherequiredcountrysetting.
WARNING!
The inverter must be configured to the proper setting in order to ensure that it complies with the
country grid code and functions properly with the country grids.
AVERTISSEMENT!
L'onduleur doit être configuré pour le pays approprié afin d'assurer un fonctionnement convenable
avec le réseau de ce pays.
3. FromtheLanguagedrop-downlist,selectthelanguage.
4. TapSet Language.
Pairing
Onceallconnectionsaremade,allthepoweroptimisersmustbelogicallypairedtotheirinverter.The
poweroptimisersdonotstartproducingpoweruntiltheyarepaired.Thisstepdescribeshowtoassign
eachinvertertothepoweroptimisersfromwhichitwillproducepower.
Performthisstepwhenthemodulesareexposedtosunlight.Ifthestringlengthischangedorapower
optimiserisreplaced,repeatthepairingprocess.
1.
Fromthemainmenu,selectPairing.
2. TapStart Pairing.
Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
43