3
Safety
• During operation, avoid touching any parts of the inverter other than the DC switch
and LCD panel (if any).
• Never connect or disconnect the AC and DC connector while the inverter is running.
• Prior to conducting any maintenance, turn off the AC and DC power and disconnect
them from the inverter. Wait for 5 minutes to fully discharge the energy.
WARNING!
Potential danger of scalding due to the hot enclosure of the inverter
• Avoid touching the inverter while it is running, as it becomes hot during operation
and may cause personal injuries.
WARNING!
• When handling the battery, carefully follow all safety instructions provided in
the battery manual. The battery used with the inverter must meet the specified
requirements of the series inverter.
WARNING!
• Use insulated tools when installing the device, and always wear personal protective
equipment during installation and maintenance.
CAUTION!
• Make sure that children are supervised to prevent them from playing with the inverter.
• Pay attention to the weight of the inverter and handle it properly to avoid personal
injuries.
• Radiation may be harmful to health! Do not stay in the vicinity of the inverter for a
long time and keep at least 20 cm away from it.
NOTICE!
• If an external Residual Current Device (RCD) is required by local regulations, verify the
type of RCD required. It is recommended to use a Type-A RCD with a rating of 300
mA. When required by local regulations, the use of a Type-B RCD is permitted.
• Keep all labels and the nameplate on the inverter clearly visible and well-maintained.
1.2.3 Safety Instructions of Utility Grid
NOTICE!
• Only connect the inverter to the grid with the permission of the local utility grid
company.
To Next Page
Loading...
