81
Operation on LCD
10.4 System ON/OFF
Setting path: Menu>System ON/OFF
Select ON or OFF to switch on and off the inverter. The interface is displayed ON by
default. When you select OFF, the inverter stops running.
====System ON/OFF====
Switch
> ON <
10.5 Mode Select
Selecting path: Menu>Mode Select
Here you can only select the working mode. Six working modes are available for you
to choose in on-grid status, i.e Self Use, Feed-in Priority, Backup mode, Peak Shaving,
TOU and Manual. You can choose the working modes according to your lifestyle and
environment. Please refer to "2.7 Working Mode" for introduction of the modes and "10.7.1
User Setting" for specific setting of each mode.
=====Mode Select=====
>Self Use
Feed-in Priority
Backup Mode
• TOU: TOU can only be set in SolaX Cloud App or Web. After setting the TOU in
the App or Web, the selected TOU mode will be displayed in TOU interface on the
LCD.
»
Min SOC: The minimum SOC of the system.
========TOU========
>Min SOC
10%
»
Self-use: Same working logic with Self-use Mode, but it is not limited by the
charging and discharging period. When the current working mode is self-
use, you can view the set minimum SOC.
========TOU========
Current Mode
Self-use
========TOU========
>Min SOC
10%
»
Feed-in Priority: Same working logic with Feed-in Priority, but it is not
limited by the charging and discharging period.
»
Battery off: The battery neither charges nor discharges. The power of PV
will supply to loads or feed into the grid. Only when the battery SOC is lower
than the system ( TOU) Min SOC, the battery can be charged.
========TOU========
Current Mode
Battery off
To Next Page
Loading...
