158
Appendix
b. Use the RJ45 connector to connect the extension communication cable and the
CTs.
EP S
Waterproof distribution box
Figure 15-23 Connecting the inverter to the CT
Setting Procedure
After connecting CT to the inverter, set parameters on the inverter.
a. CT is set by default.
b. Select Menu>Setting>Advance Setting>Meter/CT Setting and enter the Meter/
CT Setting interface according to the setting path to choose the supported CT
type (100 A by default). You can check the connection status in Meter/CT Check.
====Meter/CTSetting====
>CT Type
100A
To Next Page
Loading...
