55
Electrical Connection
Step 3: Press down the spring by hand. A "Click" will be heard if it is connected correctly.
Make sure that the spring is snapped in.
Click!
Figure 8-27 Pressing down the spring
Step 4: Push the connector into the sleeve and tighten the cable gland.
1
1
2
2
Figure 8-28 Tightening the cable grand
Step 5: Remove the battery terminal caps and connect the assembled battery connectors
to the corresponding terminals until there is an audible "Click".
Click!
Figure 8-29 Connecting the battery connector
CAUTION!
• Keep the terminal caps in a safe place if batteries are connected to the inverter.
Reinstall the caps immediately after removing the connectors from the terminals.
To Next Page
Loading...
