SolaX Power X3-Hybrid Series User Manual

The inverter have two PV inputs. Please select photovoltaic modules
with good performance and quality assurance. The open circuit voltage
of the module array should be less than the maximum PV input voltage
specified by the inverter, and the working voltage should be within the
MPPT voltage range.
Table 1: Maximum input voltage limit(apply to version D/M)
5.1 PV Connection
Warning!
The voltage of photovoltaic modules is very high, and is
dangerous voltage. When wiring, please follow the safe
electricity regulations.
Note!
Please do not make PV positive or negative ground!
Note!
The following PV module requirements need to be applied
to each input range:
1. Same model
2. Same quantity
3. The same array
4. The same angle
Ø Connection step
Electrical Connections
Electrical Connections
5 Electrical Connections
Max. DC input voltage
1000V
X3-Hybrid-5.0 X3-Hybrid-6.0 X3-Hybrid-8.0
X3-Hybrid-10.0
X3-Hybrid-12.0 X3-Hybrid-15.0
Model
Step 3. Tighten the cable with the insulation layer stripped and insert it
into the PV pin contacts (see Figure 1), make sure all wires are well
connected (see Figure 2).
Step 2. Use a wire stripper to strip the 7mm insulation layer of the wire end.
7
.
0m
m
Wire stripper
Figure 1
Figure 2
Positive PV
pin contact
Negative PV
pin contact
PV cable
PV pin contact
Positive PV connector
Negative PV connector
Positive PV pin contact
Negative PV pin contact
32
33
Notice!
The series inverters support the Multi PV connection
method.
Inverter
PV
PV 1
+
-
PV 2
+
-
X3 HYD G4
+
-
PV 1
+
-
PV 2
+
-
Inverter
+
-
PV 1
+
-
PV 2
+
-
X3 HYD G4
+
-
PV 1
+
-
PV 2
+
-
Inverter
+
-
PV 1
+
-
PV 2
+
-
X3 HYD G4
+
-
PV 1
+
-
PV 2
+
-
Inverter
+
-
2. Method 2: Common
X3-Hybrid-10.0K-D
Positive PV
pin contact
Negative PV
pin contact
Step 1. Turn off the DC switch, connect the PV module, prepare a 4
mm² PV cable, and find the PV (+) terminal and PV (-) terminal in the
package.
The PV port wiring of the M series inverter has been completed. For
specic installation details, please refer to the X3-Matebox Quick
Installation Guide, the D series needs to be wired according to the
following steps.

SolaX Power X3-Hybrid Series Specifications

General

Number of MPP Trackers	2
Model	X3-Hybrid Series
Phase	Three Phase
Communication Interfaces	RS485
Battery Compatibility	Lithium-Ion
Grid Frequency	50Hz / 60Hz
Operating Temperature	-25 ~ +60 °C