Step 6. Tighten the waterproof fastening head.Step 4. Find the location of the AC interface on the inverter, insert the
crimped terminals into the UW10 terminals L1, L2,L3,N, and PE according
to the wire sequence, and use a flat-blade screwdriver to tighten the
screws. (Torque: 1.5±0.1N·m)
Electrical Connection
Electrical Connection
44
45
Torque screwdriver
(Torque: 1.5±0.1N·m)
Hexagon keys
(Torque: 0.8±0.1N·m)
Step 5. Install the AC protective cover, and tighten the screws on
the four sides of the cover with an . Hexagon keys
(Torque: 0.4±0.1N.m)
To Next Page
Loading...
