Setting
Setting
8 ) Modbus
Here you select the baud rate of the external communication protocol.
9 ) External ATS
INCORRECT line sequence (R-R, S-S, T-T, N-N) will damage the inverter. To
avoid the damage, the default “Disable” has been set to “Enable” in “External
ATS” under “Advance Settings”. Users should set the default setting back to
“Disable”. External ATS needs to be set to “Enable” only when a matebox
advanced is connected.
Functional Control
Disable Enable
External ATS
106
107
10 ) Power Factor (applicable to specific countries, please refer to local grid
requirements)
PV1 Control
OFF/Low/Middle/High
GMPPT
Modbus
Baud Rate:
19200
Modbus
Address:
1
PV2 Control
OFF/Low/Middle/High
GMPPT
Mode Select
Under-Excited
＞ ＜
Power Factor
Mode Select
Curve ＞ ＜
Power Factor
Mode Select
Q(u) ＞ ＜
Power Factor
Mode Select
Fixed Q Power ＞ ＜
Power Factor
Mode Select
Off ＞ ＜
Power Factor
Mode Select
Over-excited ＞ ＜
Power Factor
Mode Comment
Off
Over-Excited PF value
Under-Excited PF value
Curve
PfLockInPoint (EU50549 only)
PfLockOutPoint (EU50549 only)
-
Fixed Q Power Q Power
SetQuPower1
QuRespondV1( AS4777.2 only)
3Tau
QuDelayTimer
P3_PF
P4_PF
P1_PF
P2_PF
Power 1
Power 3
Power 2
Power 4
Q( u )
SetQuPower2
SetQuPower3
SetQuPower4
QuRespondV2( AS4777.2 only)
QuRespondV3( AS4777.2 only)
QuRespondV4( AS4777.2 only)
K
3Tau
QuLockEn
QuLockSetting
Enable Disable
QuLockFunction
QuLockSetting
0%
QuLockIn
QuLockSetting
QuLockOut
0%
7 ) GMPPT
Here, you can set the shadow tracking with four options, which are
off, low, middle, and high.
To Next Page
Loading...
