109
Operation on LCD
Setting Extend BAT FUNC
This function allows for the extension of battery modules, such as adding a new battery
module to an existing system. It is only applicable and functional in on-grid mode. In on-
grid mode, enabling this function will make the inverter to charge or discharge the battery
SOC to approximately 38%. This function will turn to Disable automatically after 48 hours
this function enabled..
===Extend BAT FUNC===
> Enable <
Function Control
Setting HotStandby Settting
This function is mainly to reduce inverter system losses. In "enable" mode, the inverter
enters a hotstandby state when the load is very low, resulting in no power being supplied
to the load in order to minimize system losses.
In "disable" mode, the inverter will continue supplying power to the load even if the load is
very low, and will not enter the hotstandby state. This feature is disabled by default.
It is disabled by default.
===HotStandby Setting===
> Enable <
Function Control
Setting Pgrid Bias
This function is disabled by default.
When the inverter has no power export:
a. Check the Meter/CT value in Menu>System Status>Meter/CT when the function
is disabled.
b. If the Meter/CT displayed in System Status is negative value, please select Grid
for Pgrid Bias to discharge power to the mains. If the Meter/CT displayed in
System Status is positive value, please select INV for Pgrid Bias to take power
from the mains.
======Pgrid Bias======
> Grid <
Setting Internal485
You can communicate with other SolaX equipment, such EV Charger, Datahub, COM485
and AdapterBox G2 through Internal485.
a. Select and enter Internal485 interface;
To Next Page
Loading...
Need help?
General
