Solcon TPS - 7.7.5 Tripping;Alarm Parameters - Page 5

35 • Control Keypad
________________________________________________________________________________________________
7.7.5 Tripping/alarm prameters – page 5
For easy viewing, tripping/alarm pages are not listed as in other pages but as a table.
Notes:
1. All protections MUST be programmed in this page in order to be operative!!
2. Each of the faults listed below can be programmed as DISABLED (-) or ENABLED (+)
3. The table below shows factory defaults.
FAULT Trip Alarm Auto
Reset
Panel
Reset
Remote
Reset
Output
A
Output
B
Output
C
UNDER CURRENT
-
- - + + - - -
OVER CURRENT
+
+ - + + - - -
UNBALANCE LVL 1*
-
- - + + - - -
UNBALANCE LVL 2 *
-
- - + + - - -
UNDER VOLTAGE
- + - + + - - -
OVER VOLTAGE
+
+ - + + - - -
PHASE LOSS
+ + - + + - - -
GROUND FAULT
-
- - + + - - -
UNDER POWER
-
- - + + - - -
SHORTED SCR
- - - + + - - -
WRONG CONCT TYPE
- - - + + - - -
HEAT SINK OVER T.
+ + - + + - - -
EXTERNAL FAULT
- - - + + - - -
COMM PORT FAILED
- - - + + - - -
INTERNAL FAILURE
- - - + + - - -
* For calculation method of UNBALANCE LVL1&2 refer to section
7.7.3 on page 32.