4 • Safety & Warnings
________________________________________________________________________________________________
2. SAFETY & WARNINGS
2.1 Safety
1
Read this manual carefully before operating the equipment and follow its
instructions.
2
Installation, operation and maintenance should be in strict accordance
with this manual, national codes and good practice.
3
Installation or operation not performed in strict accordance with these
instructions will void manufacturer warranty.
4
Disconnect all power inputs before servicing the TPS and/or the load.
5
After installation, check and verify that no parts (bolts, washers, etc) have
fallen into the TPS.
2.2 Attention
1
This product was designed for compliance with IEC 947-4-3 for class A
equipment. TPS 1000V were also type tested to meet this standard.
2
Use of the product in domestic environments may cause radio
interference, in which case, the user may be required to employ
additional mitigation methods.
3
Utilization category is AC-51: 1,4 x Ie – 1 s, uninterrupted duty. For
further information, see Technical Specification
2.3 Warnings
1
Internal components and PCBs are at mains potential when the TPS is
connected to mains. This voltage is extremely dangerous and will cause
death or severe injury if contacted.
2
When TPS is connected to mains, even if control voltage is disconnected,
full voltage may appear on its output.
3
The TPS must be grounded to ensure correct operation, safety and to
prevent damage.
4
Check that Power Factor capacitors are not connected to the output side
of the soft TPS.
5
Do not interchange line and load connections
6
Phase Control Firing, may cause Radio interferences, in which case the
user may be required to employ additional mitigation methods.
The company reserves the right to make any improvements or modifications to its products without
prior notice.
To Next Page
Loading...
Need help?
General Specifications
