Sollatek JEA Series User Manual

JEA USER MANUAL
A3+ CMYK
2 I +44 (1753) 214 500
Please read the following warnings to maintain the safe function and continued performance of your Sollatek device.
INSTALLATION
Mounting of the unit must be in accordance with orientation as specied in the “Description & Install” section.
The device must only be installed and congured by trained and authorized staff as specied in the “Description &
Install” section.
WASHDOWN
The front of the unit may be exposed to water jets. The rear of the unit must not be exposed to high pressure water
jets or temporary submersion.
CHEMICALS
The Sollatek device is made of polycarbonate and should not be exposed to chemicals which attack this material.
TEMPERATURE
The Sollatek device must only be subjected to temperatures as specied in the “Technical Specications” section of
this manual.
VIBRATION AND IMPACT
The device MUST be installed in such a way as to be protected from impact in operation. Do not hit or drop the
device.
NO SERVICEABLE PARTS
There are no serviceable parts inside the device. Do NOT open the housing.
VOLTAGES
The Sollatek device must only be connected to power supplies which comply with the acceptable voltage ranges
specied in the “Technical Specication” section of this manual.
VOLTAGE FLUCTUATIONS AND SERGE
The Sollatek device has surge protection as specied in the “Technical Specication”. Exposure to surge voltages
out side these limits, or excessively repeated surges within the limits may cause damage to the electrical circuits.
CURRENTS
Outputs should not be connected to short circuits or to loads which exceed the currents specied in the “Technical
Specication” section of this manual. Care must be taken to ensure that cables and terminations are safely
terminated.
SEGREGATION OF POWER AND SIGNAL CABLING
Correct segregation of power and signal cabling must be followed. Do not run power and signal cables together in
the same conduit. Induction from power cables may corrupt data signals, leading to incorrect operation.
CONSEQUENTIAL FAILURES
The Sollatek device includes features to protect both itself and connected components. However, failure of
connected components may cause damage to the JEA controller and / or connected components. Critical or
vulnerable components should be protected independently against failure.
FIT FOR PURPOSE
The Sollatek device must only be used for the purpose and functions described in this manual. As each application
requires different conguration and setup, no liability is accepted by Sollatek UK Ltd for the correct operation of the
nal equipment.

Sollatek JEA Series Specifications

General

Brand	Sollatek
Model	JEA Series
Category	Temperature Controller
Language	English