32
Make calls
White list calls
This list contains phone numbers of persons you want to
call. The options are similar to that of Black list calls. Refer
“Black list calls” on page 31.
Call filter settings
You can enable or disable the call filter settings.
1. On the Call filter screen, select Call filter settings >
OK.
Enable black list: rejects all incoming calls from
numbers in the black list.
Enable white list: allows incoming calls from num-
bers listed in the white list, and rejects incoming calls
from numbers that are not available in the list.
Close filter: disallows filtering of incoming calls.
Other call settings
Minute reminder: when enabled prompts you at the
50th second of every minute during a conversation.
Select Menu > Settings > Call settings > Minute
reminder > On.
Send ID: when enabled displays your ID to the recipi-
ent when you call or send a message. However this
service must be supported by your network.
1. To enable this option, select Menu > Settings > Call
settings > Send ID >OK.
2. To view whether the option is enabled or not, select
Status > OK.
Review call information
1. Select Menu > Call list > Call meters > OK. The
following options are available:
Last call: displays the duration of the last call.
Last GPRS call: displays the transmitted bytes of the
last GPRS service.
Call timer: displays the duration of all the incoming or
outgoing calls. Select Reset Timer > OK to restart
the counter or meter.
Display cost: if enabled, displays the duration and
charges of the call. Disabled mode is the default mode.
If you want to enable this function, you need to
acquire a PIN2 code from your network operator.
Accum. charges: this service is only available when
your SIM card contains charging information. Use this
service to configure or view all charge information
related to your calls.
The following can be configured:
Show cost Displays total charges of
all outgoing and incoming
calls since the last reset.
To Next Page
Loading...
Need help?
General
