63
Push-To-Talk
2. Select a PTT contact, press the PTT key to initiate the
call.
3. If you select a group contact, select OK > Option >
PTT invitation > OK to initiate the call.
To proceed with the call
After you have chosen any one of the invitation modes and
have initiated the call, the screen displays Ringing.
1. Press and hold the PTT key until the top of the screen
displays Start sending Speaking. Continue to hold the
PTT key while you are speaking.
2. Release the PTT key when you finish speaking.
3. When the other person takes floor control the top of
the screen displays Start receiving Listen.
4. If you attempt to speak before the other person fin-
ishes speaking, Remote speaking is displayed on top of
the screen. Wait for the beep before you can begin
speaking.
When you end the call, the top of the screen displays PTT
call ended.
Make calls from the Standby screen
1. Press the PTT key to view the Contacts.
2. Select the contact using the Navigation key
3. Press the PTT key to initiate the call..
Make calls from the group list
A group has a set of pre-arranged members and a unique
group ID. A group PTT call is similar to a one-to-many PTT
call.
1. To access the group list select Menu > PTT > Group.
2. Scroll to a group and press the PTT key, Ringing is dis-
played on the screen.
3. When any member from the
group responds, the contact
name is displayed with a green
icon beside it. If a member has
not accepted the call a red icon
is displayed beside the contact
name. You can begin speaking
after the beep. Group session,
Start sending, Speaking is dis-
played at the top of the
screen. When you are speaking a list of all the partici-
pants in the session is displayed on the screen.
4. Continue to hold the PTT key while you are speaking
and release the key when you finish speaking.
Press and hold the PTT key to call the first con-
tact in the Contacts list.