23
Attaching a Viewfinder
Chapter 2 Installation and Preparations
3
Insert the replacement shim using the shim slit to clear
the wiring, and align the camera screw holes and shim
alignment pins.
4
Reattach the lens mount in its original position, and
fasten the screws to a torque of 0.53 N·m (0.39 lbf).
2-5 Attaching a
Viewfinder
When the viewfinder is attached, do not leave the camera
with the eyepiece facing the sun. Direct sunlight can enter
through the eyepiece, be focused in the viewfinder and
cause fire.
For details on the viewfinder, refer to the instruction
manual of the viewfinder.
1
Pass the viewfinder mounting plate over the two rods.
2
Slide the slide panel left/right into position, and then
turn the lever on the rear of the slide panel to lock it
into position.
Shim alignment pins
Caution
Viewfinder mounting plate
Slide panel
To Next Page
Loading...
