Sony HCD-MD555 - Test Mode Procedures and Displays

— 39 —
OPERATING THE CONTINUOUS PLAYBACK MODE
1. How to Enter the Continuous Playback Mode
1 Insert a disc in slot 1. (Either a recordable disc or playback-only disc can be used.) Press the MD§ button to load the disc.
2 Turn the MULTI JIG dial until “CPLAY MODE” (30) appears on the display.
3 Press the ENTER/YES button and the display changes to “CPLAY MID”.
4 When the disc is accessed, the display changes to “C=
AD= ”.
Note: The number in the “
” area on the display indicates the error rate and “ADER”.
2. How to Change the Playback Segment
1 If you press the ENTER/YES button during continuous playback, the display changes as shown below and a different segment can
be played back.
“CPLAY MID” n “CPLAY OUT” n “CPLAY IN”
2 When access to the segment is completed, the display changes to “C=
AD= ”.
Note: The number in the “
” area on the display indicates the error rate and “ADER”.
3. Ending the Continuous Playback Mode
1 Press the EDIT/NO button. The display changes to “CPLAY MODE”.
2 To remove the disc, press the MD§ button.
Note: The playback start addresses for IN, MID, and OUT are as follows.
IN : 40h cluster
MID : 300h cluster
OUT : 700h cluster
n