Sony ICD-TX660 - You Cannot Charge the Battery by Connecting the IC Recorder to Your Computer

Help Guide
IC Recorder
ICD-TX660
You cannot charge the battery by connecting the IC recorder to your computer.
The power charging connector of cables other than the supplied USB Type-C cable may not fit. Use the supplied
USB Type-C cable.
When your IC recorder is connected to a computer which is not running, the battery will not charge. When the
computer is in a power saving mode (standby or sleep), it will not charge, either.
Disconnect your IC recorder from the computer and connect it once again.
The USB Type-C cable is not properly connected.
Check the system requirements of your IC recorder.
Charge the battery under the temperature of 5 °C - 35 °C (41 °F - 95 °F).
When using a USB Type-C cable (commercially available), use one of the USB compliant cables that are designed
for data transfer and with a 56 k ohm resistor.
When a USB hub or USB extension cable (commercially available) is used for power connection, connect the
supplied USB Type-C cable to your IC recorder, and then connect the cable directly to the USB hub or USB
extension cable.
Related Topic
Charging the battery with a computer
System requirements
5-025-099-11(1) Copyright 2021 Sony Corporation
141