Soredex CRANEX Novus e - Page 19

Installation and set-up manual 208668 13
CRANEX Novus e 3. Installing the unit
4. Remove all the accessories, the accessory
box and as much packaging material as
possible.
NOTE:
DO NOT remove the packaging material that
protects the upper shelf and the rotating unit.
NOTE:
If the unit is to be attached to the exhibition
stand, see section 6. The exhibition stand
and the separate instructions supplied with
the exhibition stand.
5. Fold down the end of the box that is nearest
the hinged section of the column and then
slide the unit over the edge of the pallet so that
you can access the underside of the hinged
section of the column.
6. Support the hinged column section before
loosening the screws that hold it to prevent
it falling and causing injury or damage.
Loosen the two nuts (M10, inside the column)
that hold the hinged lower column section in
the vertical transportation position.
Lower the hinged column section down so
that it is horizontal. Secure it in position with
the two screws supplied (M10 x 16), the
fi xing holes are on the underside (rear) of the
column.
Retighten the two nuts (M10, inside the
column).