24 Installation and set-up manual 208668
3. Installing the unit CRANEX Novus e
3.8 Connecting the unit to the power supply
The unit must be connected to its own dedicated
power supply:
• 100 to 120 VAC or
• 220 to 240 VAC
No other equipment should be connected to the
same power supply.
Extension cables MUST NOT be used to connect
the unit to the power supply.
1. The power supply must be equipped with a
circuit breaker:
• 100 - 120 VAC, min. 16 A 250 VAC
• 220 - 240 VAC, min. 10 A 250 VAC.
2. Connect one end of the power lead to the
back of the unit and the other end to the power
supply.
Observe any national and local electrical
requirements with regards the connection of
dental x-ray equipment to a power supply.
To Next Page
Loading...
